IEC 60364-1 pdf download

IEC 60364-1 pdf download Low-voltage electrical installations – Part 1: Fundamental principles, assessment of general characteristics, definitions
IEC 60364-1 gives the rules for the design, erection,and verification of electrical installations.The rules are intended to provide for the safety of persons， livestock and property againstdangers and damage which may arise in the reasonable use of electrical installations and toprovide for the proper functioning of those installations.
11.1IEC 60364-1 applies to the design，erection and verification of electrical installationssuch as those of
a) residential premises;
b) commercial premises;
c) public premises;
d) industrial premises;
e) agricultural and horticultural premises;
f) prefabricated buildings;
g) caravans, caravan sites and similar sites;
h) construction sites, exhibitions, fairs and other installations for temporary purposes;i)marinas;
j)external lighting and similar installations (see, however ,11.3e));
k) medical locations;
l)mobile or transportable units;m) photovoltaic systems;
n) low-voltage generating sets.
NOTE“Premises”covers the land and all facilities including buildings belonging to it.
11.2 IEC 60364-1 covers
a) circuits supplied at nominal voltages up to and including 1 000 v a.c. or 1 500 v d.c.;
For a.c., the preferred frequencies which are taken into account in this standard are50 Hz，60 Hz ‘and 400 Hz. The use of other frequencies for special purposes is notexcluded.
b) circuits, other than the internal wiring of apparatus, operating at voltages exceeding 1 000 v
and derived from an installation having a ‘voltage not exceeding 1 00o v a.c., for example,discharge lighting, electrostatic precipitators;
c) wiring systems and cables not specifically covered by the standards for appliances;
d) all consumer installations external to buildings;
e) fixed wiring for information and communication technology, signalling, control and the like (excluding internal wiring of apparatus);
f) the extension or alteration of the installation and also parts of the existing installation affected by the extension or alteration.
NOTE The rules of IEC 60364-1 are intended to apply to electrical installations generally but, in certain cases,
they may need to be supplemented by the requirements or recommendations of other IEC standards (for example,for installations in explosive gas atmospheres).
11.3 IEC 60364-1 does not apply to
a) electric traction equipment, including rolling stock and signaling equipment;
b) electrical equipment of motor vehicles, except those covered in Part 7;
c) electrical installations on board ships and mobile and fixed offshore platforms;
d) electrical installations in aircraft;
e) public street-lighting installations which are part of the public power grid;
f) installations in mines and quarries;
g) radio interference suppression equipment, except where it affects the safety of the installation;
h) electric fences;
i) external lightning protection systems for buildings (LPS);
NOTE Atmospheric phenomena are covered in IEC 60364-1 but only insofar as effects on the electrical installations are concerned (for example, with respect to selection of surge protective devices).
j) certain aspects of lift installations;
k) electrical equipment of machines.
11.4 IEC 60364-1 is not intended to apply to
– systems for distribution of energy to the public, or
– power generation and transmission for such systems.