ASME A112.19.3 pdf download

ASME A112.19.3 pdf download Stainless steel plumbing fixtures
1 Scope
1.1
This Standard covers plumbing fixtures made of stainless steel alloys and specifies requirements for materials, construction, performance, testing, and markings.
Note: The term “corrosion-resisting steel” is also applied to stainless steel.
∆ 1.2
This Standard covers the following plumbing fixtures:
a) bathtubs;
b) bidets;
c) drinking fountains and water coolers;
d) lavatories;
e) shower bases;
f) sinks:
i) kitchen and bar sinks;
ii) laboratory sinks;
iii) laundry sinks;
iv) service sinks; and
v) utility sinks;
g) urinals; and
h) water closets.
1.3
In this Standard, “shall” is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; “should” is used to express a recommendation or that which is advised but not required; and “may” is used to express an option or that which is permissible within the limits of the Standard.
Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.
Notes to tables and figures are considered part of the table or figure and may be written as requirements.
Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.
1.4
SI units are the units of record in Canada. In this Standard, the yard/pound units are shown in parentheses. The values stated in each measurement system are equivalent in application; however, each system is to be used independently. Combining values from the two measurement systems can result in non-conformance with this Standard.
All references to gallons are to U.S. gallons.
For information on the unit conversion criteria used in this Standard, see Annex A.
2 Reference publications
This Standard refers to the following publications, and where such reference is made, it shall be to the edition listed below, including all amendments published thereto.
CSA Group
B125.3-12
Plumbing fittings
B651-12
Accessible design for the built environment
C22.2 No. 0.15-15
Adhesive labels
ASME (American Society of Mechanical Engineers)/CSA Group
ASME A112.18.1-2012/CSA B125.1-12
Plumbing supply fittings
ASME A112.18.2-2015/CSA B125.2-15
Plumbing waste fittings
ASME A112.19.2-2013/CSA B45.1-13
Ceramic plumbing fixtures
ASTM International (American Society for Testing and Materials)
A240/A240M-16
Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
ICC/ANSI (International Code Council/American National Standards Institute)
A117.1-2009
Accessible and Usable Buildings and Facilities
UL (Underwriters Laboratories Inc.)
969 (1995)
Standard for Marking and Labeling Systems