BS ISO 15372 pdf download

BS ISO 15372 pdf download Ships and marine technology — Inflatable rescue boats — Coated fabrics for inflatable chambers
1 Scope
This International Standard specifies the minimum requirements for coated fabrics, and test procedures for those fabrics, for use in the construction of inflatable chambers of rescue boats complying with the 1974 Safety of Life at Sea Convention (SOLAS), as amended; Chapter I, paragraph 1.2, and Chapter V of the International Life-Saving Appliance Code [IMO Resolution MSC.48 (66)]; and the IMO Assembly resolution A.689(17), as amended. These coated fabrics consist of a base textile with a synthetic elastomeric or plastomeric compound applied to one or both faces.
Requirements for fabrics for inflatable boats other than SOLAS rescue boats are contained in ISO 6185:1982, Shipbuilding and marine structures — Inflatable boats — Boats made of reinforced elastomers or plastomers .
2 Normative references
The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards.
ISO 1421:1998,Rubber- or plastics-coated fabrics – Determination of tensile strength and elongation at break
ISO 1817:1999Rubber, vulcanized 一 Determination of the effect of liquids.
ISO 2286-2:1998,Rubber- or plastics-coated fabrics – Determination of roll characteristics – Part 2: Methods fordetermination of total mass per unit area, mass per unit area of coating and mass per unit area of substrate.
ISO 2411:2000, Rubber- or plastics-coated fabrics – Determination of coating adhesion.
SO 3011:1997,Rubber- or plastics-coated fabrics – Determination of resistance to ozone cracking under staticconditions.
ISO 4674:1977, Fabrics coated with rubber or plastics – Determination of tear resistance
ISO 4675:1990, Rubber- or plastics-coated fabrics – Low temperature bend test
ISO 4892-2:1994,Plastics – Methods of exposure to laboratory light sources – Part 2: Xenon-arc sources.
ISO 4892-4:1994,Plastics – Methods of exposure to laboratory light sources – Part 4: Open-flame carbon-arclamps.
ISO 5470:1980, Rubber or plastics coated fabrics – Determination of abrasion resistance.
ISO 5978:1990, Rubber- or plastics-coated fabrics 一 Determination of blocking resistance
International Convention for the Safety of Life at Sea, 1974 (SOLAS 1974), as amended in 1996.
IMO Resolution MSC.48(66), Adoption of the International Life-Saving Appliance (LSA) Code.
IMO Resolution A.689(17)(as amended), Recommendation on Testing of Life-Saving Appliances.
3 General requirements
3.1 Coated fabric
3.1.1 Coated fabric for use in the construction of inflatable chambers of rescue boats shall conform to the performance requirements specified in Table 1 when type tested in accordance with the specified test procedures in clause 6.
3.1.2 Type approval of a fabric applies only to a particular colour or range of colours as tested.